PE1CKK Az-El rotator
From SatNOGS Wiki
Revision as of 11:46, 4 February 2025 by Kerel+satnogs (talk | contribs)
| PE1CKK Az-El rotator | |
|---|---|
| [[Image:|thumb|center|PE1CKK Az-El rotator]] | |
| Rotator Information | |
| Type: | Az/El |
| Cost: | |
| Release Information | |
| Status: | |
| Latest Release: | [ ] |
| Repository: | [] |
| Documentation: | [Az-El rotator] |
Introduction
A fully 3D printed Az-El system, designed by PE1CKK.
Specification
| PE1CKK Az-El rotator | |
| Plastic Parts | 20 |
| Non Printed Parts | |
| Cost | |
| Controller Electronics | |
| Type | AZ/EL |
| Motors | 2x DC Motors |
| Speed (deg/sec) | |
| Torque (Nm) | |
| Brake Torque (Nm) | |
| Dimensions (mm) | |
| Weight (kg) | |
Sourcing & parts
Bill-of-materials (collaborative sheet)
3D-printed Parts
| Part | Model Filename | Quantity |
| Bottom baseplate | baseplate_2 | 1 |
| Vertical base | vertical base | 1 |
| Big gear half | tandwiel_groot | 4 |
| Motor gear | tandwiel_motor | 2 |
| Resistor gear | tandwiel_potmeter | 2 |
| Gear clamp | lagerklem | 2 |
| Standoff ring | bus | 8 |
Other Parts
| Part | Quantity | Distributor | Price (each) | Remarks |
| Ball bearing: 35x44x5mm 6707-2R | 4 | aliexpress | 3.00 € | - Fixed typo in bearing trade number |
| Motor: Bringsmart JGY-370 12V 10rpm | 2 | aliexpress | 5.00 € | |
| L298N bridge motor controller | 1 | aliexpress | 4.00 € |
