PE1CKK Az-El rotator
From SatNOGS Wiki
PE1CKK Az-El rotator | |
---|---|
[[Image:|thumb|center|PE1CKK Az-El rotator]] | |
Rotator Information | |
Type: | Az/El |
Cost: | |
Release Information | |
Status: | |
Latest Release: | [ ] |
Repository: | [] |
Documentation: | [Az-El rotator] |
Introduction
A fully 3D printed Az-El system, designed by PE1CKK.
Specification
PE1CKK Az-El rotator | |
Plastic Parts | 20 |
Non Printed Parts | |
Cost | |
Controller Electronics | |
Type | AZ/EL |
Motors | 2x DC Motors |
Speed (deg/sec) | |
Torque (Nm) | |
Brake Torque (Nm) | |
Dimensions (mm) | |
Weight (kg) |
Sourcing & parts
Bill-of-materials (collaborative sheet)
3D-printed Parts
Part | Model Filename | Quantity |
Bottom baseplate | baseplate_2 | 1 |
Vertical base | vertical base | 1 |
Big gear half | tandwiel_groot | 4 |
Motor gear | tandwiel_motor | 2 |
Resistor gear | tandwiel_potmeter | 2 |
Gear clamp | lagerklem | 2 |
Standoff ring | bus | 8 |
Other Parts
Part | Quantity | Distributor | Price (each) | Remarks |
Ball bearing: 35x44x5mm 6707-2R | 4 | aliexpress | 3.00 € | - Fixed typo in bearing trade number |
Motor: Bringsmart JGY-370 12V 10rpm | 2 | aliexpress | 5.00 € | |
L298N bridge motor controller | 1 | aliexpress | 4.00 € |