The Raspberry Pi 3 is the reference platform for SatNOGs. As of September 2017, there are two methods of installing the SatNOGS client on a Raspberry Pi:

Using Fedora for ARM, and following the instructions at satnogs.readthedocs.io
Installing the custom-built SatNOGS Raspian image

Fedora

Start by downloading the "Server" or "Minimal" image from the the Fedora ARM project page. After that, follow the instructions at satnogs.readthedocs.io.

If you run into anything in the instructions that is unclear, please submit an issue against the documentation repository.

Raspbian

Download

Latest Raspbian SatNOGS image artifacts can be downloaded from GitLab.

Artifacts list

The current artifacts list consists of:

A Zipped image file
An Image info file
A SHA256 checksums file

Data integrity verification

You should verify the data integrity of the artifacts by checking the SHA256 checksums. On Linux, run sha256sum -c sha256sums in the directory where the artifacts are downloaded

Example:

$ sha256sum -c sha256sums 
2017-09-10-Raspbian-SatNOGS-master-lite.info: OK
image_2017-09-10-Raspbian-SatNOGS-master-lite.zip: OK

Flashing

Follow the usual Raspbian flashing instructions, and boot your Raspberry Pi.

Networking

If you are using wired ethernet you should get connectivity right away. If you are using wireless then see this doc for network configuration instructions.

Setup

SSH to the Raspberry Pi with user "pi" and password "raspberry" (no quotes). Run "sudo satnogs-setup" to set basic configuration. When it's done, the Raspberry Pi will reconfigure itself; this may take some time.

Note: you can always reconfigure the software by running "sudo satnogs-setup -n" again.

Raspberry Pi

Contents