Difference between revisions of "SatNOGS Rotator v2"
From SatNOGS Wiki
(Add more info about the v2 rotator) |
m |
||
| Line 35: | Line 35: | ||
* [https://community.libre.space/t/iz5rzr-satnogs-v-2-from-italy/1001 IZ5RZR Satnogs V.2 from Italy] | * [https://community.libre.space/t/iz5rzr-satnogs-v-2-from-italy/1001 IZ5RZR Satnogs V.2 from Italy] | ||
* [https://community.libre.space/t/newbie-wants-to-build-a-v2-ground-station/3189 Newbie wants to build a V2 ground station] | * [https://community.libre.space/t/newbie-wants-to-build-a-v2-ground-station/3189 Newbie wants to build a V2 ground station] | ||
| + | |||
| + | [[ Category:Rotator ]] | ||
Revision as of 00:26, 1 February 2019
| SatNOGS Rotator v2 | |
|---|---|
| Rotator Information | |
| Type: | Az/El |
| Cost: | ~200 (with electronics) |
| Release Information | |
| Status: | Beta |
| Latest Release: | v2 |
| Repository: | gitlab |
| Documentation: | dozuki |
Intro
v2 is the first attempt to build a rotator for SatNOGS project.
Assembly
Assembly instructions can be found here.
All the parts are placed here. The electronics and firmware to control the motors are placed here. The v2 rotator could be also controlled by the v2.2 controller. The v2.2 rotator controller wiki.
In the v1 board the new firmware hasn't been tested. At first changes in rotator_pins.h header file must be done to match with v1 board pins. But the different mcu Atmega32u4, optiboot bootloader and WDT peripheral may create problems to nominal operation of the rotator.
Related posts in libre space community:
