Difference between revisions of "Rotators"
From SatNOGS Wiki
m |
(not a big enough page for a TOC) |
||
| Line 1: | Line 1: | ||
| − | + | __NOTOC__ | |
==SatNOGS Rotators== | ==SatNOGS Rotators== | ||
Our tracking mechanism is designed from scratch, parametric by default, 3D printed in under 8 hours. Utilizing two NEMA14 stepper motors we have unconstrained movement in Altitude and Azimuth. | Our tracking mechanism is designed from scratch, parametric by default, 3D printed in under 8 hours. Utilizing two NEMA14 stepper motors we have unconstrained movement in Altitude and Azimuth. | ||
Revision as of 01:30, 1 February 2019
SatNOGS Rotators
Our tracking mechanism is designed from scratch, parametric by default, 3D printed in under 8 hours. Utilizing two NEMA14 stepper motors we have unconstrained movement in Altitude and Azimuth.
SatNOGS Rotator v2
SatNOGS Rotator v3
Commercial rotators
Yaesu G800
Yaesu G-5500
SPID X-Y
Electronics
Our driving electronics are made of two Stepper motor drivers and an Arduino controlling them. Simple yet accurate.
