Difference between revisions of "Rotators"
From SatNOGS Wiki
(Add link to Rotator Controller page) |
m |
||
| Line 28: | Line 28: | ||
* [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator-controller Design files] | * [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator-controller Design files] | ||
* [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator-firmware Firmware] | * [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator-firmware Firmware] | ||
| + | |||
| + | [[ Category:Rotator ]] | ||
Revision as of 00:26, 1 February 2019
Contents
SatNOGS Rotators
Our tracking mechanism is designed from scratch, parametric by default, 3D printed in under 8 hours. Utilizing two NEMA14 stepper motors we have unconstrained movement in Altitude and Azimuth.
SatNOGS Rotator v2
SatNOGS Rotator v3
Commercial rotators
Yaesu G800
Yaesu G-5500
SPID X-Y
Electronics
Our driving electronics are made of two Stepper motor drivers and an Arduino controlling them. Simple yet accurate.
