Difference between revisions of "SatNOGS Rotator v2"
From SatNOGS Wiki
(Add more info about the v2 rotator) |
(adding deprecation warning) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | {{Warning|v2 of the SatNOGS rotator has been deprecated with the much more robust [[SatNOGS Rotator v3]]. If you are starting a new build please consider building v3 instead. This documentation is provided for historical purposes.}} | ||
{{Template:Rotator | {{Template:Rotator | ||
|Rotator-Name=SatNOGS Rotator v2 | |Rotator-Name=SatNOGS Rotator v2 | ||
| Line 35: | Line 36: | ||
* [https://community.libre.space/t/iz5rzr-satnogs-v-2-from-italy/1001 IZ5RZR Satnogs V.2 from Italy] | * [https://community.libre.space/t/iz5rzr-satnogs-v-2-from-italy/1001 IZ5RZR Satnogs V.2 from Italy] | ||
* [https://community.libre.space/t/newbie-wants-to-build-a-v2-ground-station/3189 Newbie wants to build a V2 ground station] | * [https://community.libre.space/t/newbie-wants-to-build-a-v2-ground-station/3189 Newbie wants to build a V2 ground station] | ||
| + | |||
| + | [[ Category:Rotator ]] | ||
Latest revision as of 20:58, 2 February 2019
v2 of the SatNOGS rotator has been deprecated with the much more robust SatNOGS Rotator v3. If you are starting a new build please consider building v3 instead. This documentation is provided for historical purposes.
| SatNOGS Rotator v2 | |
|---|---|
| Rotator Information | |
| Type: | Az/El |
| Cost: | ~200 (with electronics) |
| Release Information | |
| Status: | Beta |
| Latest Release: | v2 |
| Repository: | gitlab |
| Documentation: | dozuki |
Intro
v2 is the first attempt to build a rotator for SatNOGS project.
Assembly
Assembly instructions can be found here.
All the parts are placed here. The electronics and firmware to control the motors are placed here. The v2 rotator could be also controlled by the v2.2 controller. The v2.2 rotator controller wiki.
In the v1 board the new firmware hasn't been tested. At first changes in rotator_pins.h header file must be done to match with v1 board pins. But the different mcu Atmega32u4, optiboot bootloader and WDT peripheral may create problems to nominal operation of the rotator.
Related posts in libre space community:
