Difference between revisions of "Talk:SatNOGS Rotator Controller"
From SatNOGS Wiki
(Created page with "while building the controller i stumbled across some questions which could be explained more clearly (at least from a beginner point of view) * pros and cons of using microst...") |
(→For Newbies) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 4: | Line 4: | ||
* should r4 and r7 be soldered when using full steps or shall they be ignored at all? | * should r4 and r7 be soldered when using full steps or shall they be ignored at all? | ||
* pros and cons of using uart vs. r485 | * pros and cons of using uart vs. r485 | ||
| + | |||
| + | == For Newbies == | ||
| + | |||
| + | A section could exist to explain how to make the connections for the power supply. I could not find it anywhere and if it exists already a link could be put to it. | ||
| + | |||
| + | There are a lot of photos but it would be useful to have something close to a complete assembled rotator controller in the metallic box. | ||
Latest revision as of 00:47, 30 January 2019
while building the controller i stumbled across some questions which could be explained more clearly (at least from a beginner point of view)
- pros and cons of using microstepping
- should r4 and r7 be soldered when using full steps or shall they be ignored at all?
- pros and cons of using uart vs. r485
For Newbies
A section could exist to explain how to make the connections for the power supply. I could not find it anywhere and if it exists already a link could be put to it.
There are a lot of photos but it would be useful to have something close to a complete assembled rotator controller in the metallic box.
