Difference between revisions of "Software Defined Radio"

From SatNOGS Wiki
(Add link to forum discussion on hardware radios + summary)
(SDR)
Line 1: Line 1:
 
==SDR==
 
==SDR==
Based on the versatile
+
SatNOGS uses the R820T RTL-SDR as the default signal receiver and tuner.  The RTL-SDR is based on two chips, the versatile [http://www.realtek.com.tw/products/productsView.aspx?Langid=1&PFid=35&Level=4&Conn=3&ProdID=257 RTL2832U chip] and the [https://rtl-sdr.com/wp-content/uploads/2013/04/R820T_datasheet-Non_R-20111130_unlocked.pdf R820T tuner]. The RTL-SDR is currently the cheapest, most common, and most performing solution available in terms of general sensitivity having a frequency range of 24 – 1766 MHz.  
[http://www.realtek.com.tw/products/productsView.aspx?Langid=1&PFid=35&Level=4&Conn=3&ProdID=257 RTL2832U chip], SatNOGS is using R820T RTL-SDR as the default signal receiver and tuner. The R820T RTL-SDR is currently the cheapest, most common, and most performing solution available in terms of general sensitivity having a frequency range of 24 – 1766 MHz. The stack allows usage of other receivers too (like amateur radio transceivers) through the usage of rigctld (part of [https://sourceforge.net/projects/hamlib/ Ham Lib project]).
+
 
 +
The stack allows the use of other receivers too (like amateur radio transceivers) through rigctld (part of [https://sourceforge.net/projects/hamlib/ Ham Lib project]).
  
 
==HW Radio==
 
==HW Radio==

Revision as of 10:53, 15 June 2018

SDR

SatNOGS uses the R820T RTL-SDR as the default signal receiver and tuner. The RTL-SDR is based on two chips, the versatile RTL2832U chip and the R820T tuner. The RTL-SDR is currently the cheapest, most common, and most performing solution available in terms of general sensitivity having a frequency range of 24 – 1766 MHz.

The stack allows the use of other receivers too (like amateur radio transceivers) through rigctld (part of Ham Lib project).

HW Radio

This thread discusses the possibility of using standard amateur radios. In general:

  • You should be able to use any rotator supported by hamlib
  • Gpredict support for your radio will make things much easier
  • The satellites you'll be able to decode may be limited; filters have been developed for RTL-SDR, and won't be available for your radio.