Difference between revisions of "Rotators"
From SatNOGS Wiki
(Tidy links to rotator pages and design files) |
(Update Github links to Gitlab.) |
||
| Line 6: | Line 6: | ||
* [[SatNOGS Rotator v2|Wiki page]] | * [[SatNOGS Rotator v2|Wiki page]] | ||
| − | * [https:// | + | * [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator/tree/v2 Design files] |
===SatNOGS Rotator v3=== | ===SatNOGS Rotator v3=== | ||
* [[SatNOGS Rotator v3|Wiki page]] | * [[SatNOGS Rotator v3|Wiki page]] | ||
| − | * [https:// | + | * [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator/tree/v3.0 Design files] |
==Commercial rotators== | ==Commercial rotators== | ||
| Line 23: | Line 23: | ||
==[[SatNOGS Rotator Controller|Electronics]]== | ==[[SatNOGS Rotator Controller|Electronics]]== | ||
| − | + | Our driving electronics are made of two Stepper motor drivers and an Arduino controlling them. Simple yet accurate. | |
| − | + | * [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator-controller Design files] | |
| + | * [https://gitlab.com/librespacefoundation/satnogs/satnogs-rotator-firmware Firmware] | ||
Revision as of 21:28, 24 September 2017
Contents
SatNOGS Rotators
Our tracking mechanism is designed from scratch, parametric by default, 3D printed in under 8 hours. Utilizing two NEMA14 stepper motors we have unconstrained movement in Altitude and Azimuth.
SatNOGS Rotator v2
SatNOGS Rotator v3
Commercial rotators
Yaesu G800
Yaesu G5500
SPID X-Y
Electronics
Our driving electronics are made of two Stepper motor drivers and an Arduino controlling them. Simple yet accurate.
