Fldigi CW

From SatNOGS Wiki
Revision as of 06:34, 9 June 2018 by WA4OSH (talk | contribs) (How to)

In this example, Fldigi is being used to decode the CW beacon from the 33499 - KKS-1 satellite. The center frequency is set for 800Hz and the morse code rate set around 15 +/- 2 WPM.

FldigiCW156704.png

How to

  • Convert the captured .ogg audio file to .wav. On a Linux command line, the conversion looks like this:
$sox satnogs_ObservationNumber_YYYY-MM-DD-SomeMoreStuff.ogg ObservationAudio.wav
  • Launch Fldigi
  • Click on File, Audio, Playback. Then select the .wav file.
  • Set Op Mode to CW
  • Adjust the center frequency to where the CW signal appears on the waterfall display.
  • Configure modems, CW, General. Set the BW and WPM to match the signal you want to decode. Save, close.