Difference between revisions of "Fldigi CW"

From SatNOGS Wiki
(Initial creation, picture & text)
 
(added the how to)
Line 2: Line 2:
  
 
<p>[[File:FldigiCW156704.png]]</p>
 
<p>[[File:FldigiCW156704.png]]</p>
 +
 +
== How to ==
 +
* Convert the captured .ogg audio file to .wav
 +
* Launch Fldigi
 +
* Click on File, Audio, Playback.  Then select the .wav file.
 +
* Set Op Mode to CW
 +
* Adjust the center frequency to where the CW signal appears on the waterfall display.
 +
* Configure modems, CW, General.  Set the BW and WPM to match the signal you want to decode. Save, close.

Revision as of 06:14, 9 June 2018

In this example, Fldigi is being used to decode the CW beacon from the 33499 - KKS-1 satellite. The center frequency is set for 800Hz and the morse code rate set around 15 +/- 2 WPM.

FldigiCW156704.png

How to

  • Convert the captured .ogg audio file to .wav
  • Launch Fldigi
  • Click on File, Audio, Playback. Then select the .wav file.
  • Set Op Mode to CW
  • Adjust the center frequency to where the CW signal appears on the waterfall display.
  • Configure modems, CW, General. Set the BW and WPM to match the signal you want to decode. Save, close.