Build

From SatNOGS Wiki
Revision as of 23:48, 11 March 2018 by Acinonyx (talk | contribs) (Add Debian system as a platform)

Intro

Thanks for your interest on building a satellite ground station!

First things first: you need to understand all the different components of a ground station. Read on to learn more about ground stations. Once you have familiarized yourself with all the components, you need to make a selection on what you are going to be building (and/or buying).

Options for Ground Stations

A satellite ground station is made up from different parts. The following diagram can help you select your setup based on your needs and/or your existing setup.

Satnogs imagemap.png

Here are some links explaining the different options:

Platform Controller Rotator Radio Antenna
Raspberry Pi 3 SatNOGS Controller SatNOGS Rotator SDR Yagi
Debian system Rot2Prog SPID Big RAS Transceiver Helical
Linux Desktop lsf-g5500 Yaesu G5500 Vertical
No rotator Cross-Yagi
Idea.png
Use the above table to select your setup. E.g. SatNOGS Network > SatNOGS Client > RaspberryPi > Yaesu G550 > Kenwood TS2000 > UHF helical & VHF Cross Yagi

How do I pick?

Client: The Raspberry Pi 3 is the reference platform for SatNOGS, and is currently the option that has the best support from the community. Certain SDRs may benefit from a more powerful CPU, like what you'd find in a desktop machine; however, currently you'll need to set that up on your own.

Rotator: A rotator, like the SatNOGS Rotator v3, will allow your antenna to follow satellites as they move across the sky, and thus pick up fainter signals. But if you want to get started quickly, or don't have the hardware skills to build your own, you can still pick up stronger signals (the ISS, NOAA and Meteor weather satellites) with a no-rotator setup. If you already have a rotator supported by rotctl, you can use that.

Signal Reception: The reference radio for SatNOGS is the RTL-SDR v3, but other latest-generation SDRs like the NooElec NESDR SMart should work as well. Higher-end SDRs should work as well, but can get a bit expensive. Alternately, any radio supported by rigctl should work.

Amplification is generally done by a low noise amplifier, or LNA. There are multiple options:

  • A wide-band LNA next to your SDR (see LNA4ALL and similar)
  • A band specific (or two) pre-amplifiers next to your antennas (example)
  • No amplification at all...just pump the gain of your SDR. (This is not recommended for the rtl-sdr.)

Antenna: Stationary antennas (eg: Turnstile, Lindenblad) will be easy to build and mount, as they won't require rotator hardware. They will let you receive stronger broadcasts, like NOAA weather satellites and ISS broadcasts, but may not work for receiving fainter cubesat broadcasts. Directional antennas (eg: Yagis, Helicals) can be more complicated to build, but will also require a rotator to track satellites across the sky. The advantage is that they will let you pick up fainter broadcasts from cubesats or ham radio satellites.

Next steps

Once you have a ground station ready, you should go ahead and operate it! More info can be found on the Operation wiki page.