Difference between revisions of "Build"

From SatNOGS Wiki
Line 20: Line 20:
| [[Raspberry_Pi_3|Raspberry Pi 3]]
| [[Raspberry_Pi_3|Raspberry Pi 3]]
| [[SatNOGS_Client|SatNOGS Client]]
| [[SatNOGS_Client|SatNOGS Client]]
| SatNOGS Controller
| [[SatNOGS Controller|SatNOGS_Rotator_Controller]]
| [[SatNOGS_Rotator_v3|SatNOGS Rotator]]
| [[SatNOGS_Rotator_v3|SatNOGS Rotator]]
| [[Radio#SDR|SDR]]
| [[Radio#SDR|SDR]]

Revision as of 18:23, 2 October 2017


Satnogs options.jpg

Thanks for your interest on building a satellite ground station! First things first: you need to understand all the different components of a ground station. Read on to learn more about ground stations. Once you have familiarized yourself with all the components, you need to make a selection on what you are going to be building (and/or buying). Below you can find a table outlining all the different options.

Options for Ground Stations

A satellite ground station is made up from different parts. The following diagram can help you select your setup based on your needs and/or your existing setup.

Hardware Software Controller Rotator Radio Antenna
Raspberry Pi 3 SatNOGS Client SatNOGS_Rotator_Controller SatNOGS Rotator SDR Yagi
Linux Desktop Rot2Prog SPID Big RAS Transceiver Helical
lsf-g5500 Yaesu G5500 Vertical
No rotator Cross-Yagi
Use the above table to select your setup. E.g. SatNOGS Network > SatNOGS Client > RaspberryPi > Yaesu G550 > Kenwood TS2000 > UHF helical & VHF Cross Yagi

Next steps

Once you have a ground station ready, you should go ahead and operate it! More info can be found on the Operation wiki page.